Analisys Of Implementation Of Workplace Accident Risk Management Using The Hirarc (Hazard Identification, Risk Assessment and Risk Control) and FTA (Fault Tree Analysis) METHOD
Analisa Penerapan Manajemen Risiko Kecelakaan Kerja Menggunakan Metode Hirarc (Hazard Identification, Risk Assessment and Risk Control) Dan FTA (Fault Tree Analysis)
DOI:
https://doi.org/10.21070/ups.9593Keywords:
Risk Manajement, HIRARC, Fault Tree AnalysisAbstract
This research is motivated by increasing work accidents at PT XYZ's transit warehouse, which has seen a sharp increase from 4 incidents in 2019 to 13 incidents in 2022. The dominant incidents have been fires or electric shocks, being hit by forklifts, and hot splashes from melted plastic bottles. To overcome this problem, a combined approach of HIRARC (Hazard Identification, Risk Assessment, and Risk Control) and Fault Tree Analysis (FTA) is employed to identify potential hazards, assess the level of risk, and formulate effective control measures. The identification results revealed one high level risk (fire/electric shock) and two moderate levels (being hit by a forklift and splashing heat). At the same time, the FTA analysis showed that the failure came from a combination of human factors (unalert operator, unaware workers of danger), equipment (open wires, unmaintained forklift, inaccurate temperature sensor), and environment (humid area, no zoning, high charging temperature).
Downloads
References
Winda PurnamaTagueha, Jantje B Mangare, and Tisano Tj. Arsjad, “Manajemen Resiko Keselamatan dan kesehatan Kerja (K3) Pada Proyek Kontruksi (Studi Kasus: Pembangunan Gedung Laboratorium Fakultas Teknik Unsrat),” Sipil Statik, vol. 6, no. 11, pp. 907–916, 2018.
W. Wahyudi, H. B. Santoso, and A. Komari, “Penerapan Manajemen Risiko Guna Mengetahui Tingkat Kecelakaan Kerja Pada Pekerjaan Pigging Di Area Sisi Nubi Total E & P Indonesie,” JURMATIS J. Ilm. Mhs. Tek. Ind., vol. 1, no. 2, p. 66, 2019, doi: 10.30737/jurmatis.v1i2.439.
N. I. Mardlotillah, “Manajemen Risiko Keselamatan dan Kesehatan Kerja Area Confined Space,” Higeia J. Public Heal. Res. Dev., vol. 4, no. Special 1, pp. 315–327, 2020.
R. Darmawan, N. Ummi, and A. Umyati, “Metode Hazard Identification And Risk Assessment ( Hira ) Di Area Batching Plant Pt Xyz.,” J. Tek. Ind., vol. 5, no. 3, pp. 308–313, 2017.
K. P. Sari, M. Chairi, and R. P. Helin, “Analisis Risiko K3 Pada Proyek Gedung Rsud Pasaman Barat Dengan Metode Hirarc,” J. Rivet, vol. 2, no. 01, pp. 25–31, 2022, doi: 10.47233/rivet.v2i01.491.
M. Afandi, S. K. Anggraeni, and A. S. Mariawati, “Manajemen Risiko K3 Menggunakan Pendekatan HIRARC (Hazard Identification, Risk Assessment and Risk Control) Guna Mengidentifikasi Potensi Hazard”.
S. Rosimah Fakultas Teknik and Y. Kurniawan, “Analisis Risiko Keselamatan Kerja dengan Menggunakan Metode Hirarc dan FTA Di PT X,” vol. 19, no. 1, 2022.
N. F. Fatma and D. E. M. Putra, “Usulan Perbaikan Pada Penerapan Sistem Manajemen Keselamatan Dan Kesehatan Kerja Di Pt. Surya Toto Indonesia Tbk Divisi Sanitary Dengan Metode Hira Dan Fta,” J. Ind. Manuf., vol. 6, no. 1, p. 27, 2021, doi: 10.31000/jim.v6i1.4116.
R. Riyadi, O. Hendra, R. Sadiatmi, W. Nugraha, and D. Amalia, “Potensi Bahaya pada Ujung Runway 24 Bandar Udara: Sebuah Implementasi Manajemen Resiko,” J. Airpt. Eng. Technol., vol. 1, no. 2, pp. 54–60, 2021, doi: 10.52989/jaet.v1i2.13.
D. S. Purnama, “Analisa Penerapan Metode HIRARC Dan HAZOPS Dalam Kegiatan Identifikasi Potensi Bahaya dan Resiko pada Proses Unloading Unit Di PT. Toyota Astra Motor,” J. PASTI, vol. 3, no. 3, pp. 103–111, 2015.
S. S. A. Rumae, S. S. Russeng, and N. U. Mahmud, “Penerapan Manajemen Risiko Dengan Metode Hirarc Dalam Mencapai Zero Accident Di Pt. Iki Makassar,” J. Kesehat. Tambusai, vol. 4, no. 2, pp. 850–859, 2023.
T. Dahniar and F. Dwi Ibnu, “Penerapan Metode Hirarc Untuk Pengelolaan Risiko Kesehatan Dan Keselamatan Kerja Di Industri Besi,” Ind. Inov. J. Tek. Ind., vol. 15, no. 1, pp. 34–39, 2025, doi: 10.36040/industri.v15i1.12123.
Della Putri Adjani and Restu Hikmah Ayu Murti, “Identifikasi Bahaya Menggunakan Metode HIRARC Pada Pekerjaan Pemeliharaan Gardu dan Jaringan Distribusi PT PLN UP3 Cengkareng,” Antigen J. Kesehat. Masy. dan Ilmu Gizi, vol. 2, no. 2, pp. 39–51, 2024, doi: 10.57213/antigen.v2i2.257.
N. M. Dewantari, A. Umyati, and F. Falah, “Hazard identification risk assessment and risk control (HIRARC) pada pembangunan gedung business center,” J. Ind. Serv., vol. 8, no. 1, p. 1, 2022, doi: 10.36055/jiss.v8i1.14405.
M. Yolanda, Y. Ekawati, and S. Noya, “Penerapan Metode Fault Tree Analysis Untuk Mencegah Kegagalan Pada Departemen Interior di PT X,” J. Sains dan Apl. Keilmuan Tek. Ind., vol. 3, no. 1, pp. 49–58, 2023, doi: 10.33479/jtiumc.v3i1.49.
A. Syarifudin and J. T. Putra, “Analisa Risiko Kegagalan Komponen Pada Excavator Komatsu 150lc Dengan Metode FTA Dan FMEA Di PT. XY,” J. InTent, vol. 4, no. 2, pp. 99–109, 2021.
Downloads
Additional Files
Posted
License
Copyright (c) 2026 UMSIDA Preprints Server
This work is licensed under a Creative Commons Attribution 4.0 International License.
