Preprint has been published in a journal as an article
Preprint / Version 1

Investigation of Plate Scale Testing for Heat Exchanger with Various Acid Solutions


Investigasi Pengujian Kerak Plat untuk Heat Exchanger dengan Variasi Larutan Asam

##article.authors##

DOI:

https://doi.org/10.21070/ups.6483

Keywords:

Heat Exchanger, Plate and Gasket, corrosion, phosphoric acid(H3PO4), hydrogen peroxide (H2O2), Chemical Descaler P 100, Metallographic test

Abstract

This study examines the effectiveness of three types of chemical liquids in descaling Heat Exchanger Plate and Gasket and their impact on corrosion. The experimental method was carried out by immersing the plate in three fluids: Phosphoric Acid/H3PO4 (yellow), Hydrogen peroxide/H2O2 (red), and Chemical Descaler P 100 (green) for 30 minutes. Test results showed that Chemical Descaler P 100 had the most effective descaling ability, but also caused significant uniform attack. Phosphoric Acid descaled well without causing significant corrosion, while H2O2 showed pitting corrosion but was less effective in descaling. In conclusion, phosphoric acid, characterized by its yellow color, gave the best results with adequate descaling and the least corrosion impact.

Downloads

Download data is not yet available.

References

D. Suastiyanti, Y. Fatanur, and P. Rupajati, "Analisis Kerusakan Tube Heat Exchanger Menggunakan Metode Remote Field Testing (RFT)," Jurnal Teknik Mesin ITI, vol. 4, no. 3, pp. 73-83, 2020.

Z. N. Jofalo And P. H. Tjahjanti, “Analisa Laju Penembusan Korosi Pada Baja Karbon Rendah Dengan Coating Aluminium Analysis Of Corrosion Breakdown Rate In Low Carbon Steel With Aluminum Coating,” Vol. 1, No. 1, 2021.

A. Journal, “Pengoperasian Dan Perawatan Sistem Pendingin Pada Mesin Induk Kapal Km . Sido Mulyo Santoso Di Ppn Sibolga Operation And Maintenance Of Cooling System On Main Engine Km . Sido Mulyo Santoso At Ppn Sibolga,” Vol. 2, No. April, Pp. 93–100, 2021.

I. E. Rahayu And S. N. Izzah, “Analisis Kinerja Heat Exchanger Pada Preheater Cdu V Di Kilang Ru V Balikpapan,” Vol. 1, No. 1, Pp. 1–9, 2021, Doi: 10.46964/Jimsi.V1i1.614.

D. Pangestu, Pengaruh Proses Quenching pada Stainless Steel 316L dengan Media Pendingin Inhibitor Tanin terhadap Proses Laju Korosi, Nilai Kekerasan, dan Struktur Mikro di Lingkungan Geothermal, M.S. thesis, UPN Veteran Yogyakarta, 2024.

J. T. Kimia, P. N. Malang, J. Soekarno, And H. No, “Evaluasi Efisiensi Heat Exchanger ( He - 4000 ) Dengan Metode Kern,” Vol. 6, No. 9, Pp. 415–421, 2020.

I. Alief, I. Qbal, et al., "Efektivitas Perubahan Fase Material KCl/H2O sebagai Sistem Pendingin Ikan Laut," Jurnal Fisika Unand, vol. 13, no. 1, pp. 8-14, 2024

G. Marausna and I. R. Putra, "Analisa Performa Heat Exchanger dengan Penambahan Vortex Generator Tipe Wirecoil Guna Mencegah Icing pada Karburator," Teknika STTKD: Jurnal Teknik, Elektronik, Engine, vol. 10, no. 1, pp. 31-43, 2024.

F. Az Zahra and H. D. E. Pratama, Optimasi Kinerja Heat Exchanger pada Unit Asam Fosfat, M.S. thesis, Institut Teknologi Sepuluh Nopember, 2023.

N. A. Zafira, "Studi Penambahan Asap Cair Tempurung Kelapa Food Grade (Grade 2) sebagai Inhibitor Kerak Magnesium Karbonat (MgCO₃) Menggunakan Metode Seeded Experiment," 2023.

A. T. Wahyudi, F. Leestiana, And R. Widodo, “Evaluasi Kinerja Heat Exchanger Pada Fasilitas Kilang Ppsdm Migas Dengan Metode Perhitungan Fouling Factor,” 2022.

E. Penambahan, B. O. Suhu, S. Fisis, And S. Kristal, “Efek Penambahan Sio 2 Dan B 2 O 3 Terhadap Suhu Sintering , Sifat Fisis, Struktur Kristal Dan Mikrostruktur Pada Keramik Sic,” Vol. 4, No. 1, Pp. 18–26, 2020.

S. Suwarso, et al., "Perawatan Penukar Panas/Heat Exchanger untuk Meningkatkan Kinerja Mesin Pendingin pada Kapal Niaga," Innovative: Journal of Social Science Research, vol. 4, no. 3, pp. 11586-11597, 2024.

T. Cahyono And P. H. Tjahjanti, “Analisa Pengelasan Tungsten Inert Gas ( Tig ) Pada Material Titanium ( Ti-6al-4v ),” No. 2, Pp. 1–13, 2024.

P. H. Tjahjanti, R. Firdaus, And A. N. Irfian, “Corrosion Protection Of Low Carbon Steel By Coating Of Graphene Oxide Nanoparticles And Galvanization Process,” Vol. 12, No. 1, Pp. 20–27, 2022, Doi: 10.22052/Jns.2022.01.003.

Posted

2024-08-27